Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
443User Manual 1335.9090.02 ─ 09
PROBe<m>:SETup:GAIN:MANual <ManualGain>
Sets the gain of the probe. The gain the the reciprocal of the attenuation (PROBe<m>:
SETup:ATTenuation:MANual)
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<ManualGain> Range: 0.0001 to 10000
17.4.5 Active probes
The commands if this chapter are only valid for Rohde & Schwarz active probes.
PROBe<m>:SETup:MODE............................................................................................. 443
PROBe<m>:ID:BUILd?...................................................................................................444
PROBe<m>:ID:PARTnumber?.........................................................................................444
PROBe<m>:ID:PRDate?.................................................................................................444
PROBe<m>:ID:SRNumber?............................................................................................445
PROBe<m>:ID:SWVersion?............................................................................................445
PROBe<m>:SETup:TYPE?.............................................................................................445
PROBe<m>:SETup:NAME?............................................................................................ 445
PROBe<m>:SETup:BANDwidth?.....................................................................................446
PROBe<m>:SETup:ATTenuation[:AUTO]?........................................................................446
PROBe<m>:SETup:GAIN[:AUTO]?..................................................................................446
PROBe<m>:SETup:CAPacitance?...................................................................................446
PROBe<m>:SETup:IMPedance?..................................................................................... 447
PROBe<m>:SETup:ADVanced:PMToffset.........................................................................447
PROBe<m>:SETup:DEGauss......................................................................................... 447
PROBe<m>:SETup:ADVanced:STPRobe......................................................................... 447
PROBe<m>:SETup:ADVanced:ZADJust...........................................................................448
PROBe<m>:SETup:PRMode...........................................................................................448
PROBe<m>:SETup:ZAXV...............................................................................................449
PROBe<m>:SETup:ADVanced:AUDioverload................................................................... 449
PROBe<m>:SETup:ADVanced:FILTer.............................................................................. 449
PROBe<m>:SETup:ADVanced:RANGe............................................................................449
PROBe<m>:SETup:ACCoupling......................................................................................450
PROBe<m>:SETup:MODE <Mode>
Selects the action that is started with the probe button.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<Mode> RCONtinuous | RSINgle | AUToset | NOACtion
Waveform setup