Remote control commands
R&S
®
RTM3000
447User Manual 1335.9090.02 ─ 09
Return values:
<InputCapacitance> Range: 0.1e-12 to 1.0e-9
Increment: 1.0e-12
Default unit: F
Usage: Query only
PROBe<m>:SETup:IMPedance?
Returns the termination of the probe.
Suffix:
<m>
.
Selects the input channel. The number of channels depends on
the instrument.
Return values:
<Termination> 50OHm | 1MOHm | UNKNown
Usage: Query only
PROBe<m>:SETup:ADVanced:PMToffset
Sets the measured ProbeMeter's DC mean value as offset. Make sure that the Probe-
Meter is active before you use this command.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Usage: Event
PROBe<m>:SETup:DEGauss
Demagnetizes the core if it has been magnetized by switching the power on and off, or
by an excessive input. Always demagnetize the probe before measurement. The
demagnetizing process takes about one second.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Usage: Event
PROBe<m>:SETup:ADVanced:STPRobe
This command is relevant only for R&S RT-ZCxxB current probes. It saves the zero
adjust value in the probe box. If you connect the probe to another channel or to
another oscilloscope with Rohde & Schwarz probe interface, the value is read out
again.
Waveform setup
To Next Page
Loading...
Need help?
General
