Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
598User Manual 1335.9090.02 ─ 09
SYSTem:BEEPer:ERRor:STATe
Enables or disables the beep if an error occurs.
Parameters:
<ErrorBeep> ON | OFF
SYSTem:BEEPer:TRIG:STATe
Enables or disables the beep if a trigger occurs.
Parameters:
<TriggerBeep> ON | OFF
SYSTem:BEEPer[:IMMediate]
Generates an immediate beep. You can use this command, for example, to locate the
instrument.
Usage:
Event
SYSTem:SET <Setup>
Defines or queries the device settings that can be saved and load manually with [File]
> "Device Settings".
Parameters:
<Setup> 488.2 block data
Usage: SCPI confirmed
SYSTem:ERRor[:NEXT]?
Returns the oldest item of the error/event queue and removes it from the queue.
Return values:
<Error> Error/event_number,"Error/event_description>[;Device-depend-
ent info]"
Example:
0,"No error"
Usage: Query only
SCPI confirmed
SYSTem:ERRor:ALL?
Returns a list of all error/event numbers and their description, and removes it from the
error/event queue.
General instrument setup