Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
562User Manual 1335.9090.02 ─ 09
BPLot:REPeat............................................................................................................... 564
BPLot:RESet................................................................................................................. 564
BPLot:STATe................................................................................................................. 564
BPLot:ENABle
Enables the Bode plot diagram.
Parameters:
<PlotEnable> ON | OFF
*RST: OFF
BPLot:AUToscale
Sets the start and stop frequencies for the Bode plot automatically.
Usage:
Event
BPLot:AMPLitude:PROFile:COUNt
Sets the number of different points that you can define for the amplitude profile.
Parameters:
<NumberOfPoints> Range: 2 to 16
Increment: 1
*RST: 4
BPLot:AMPLitude:PROFile:POINt<n>:AMPLitude
Sets the amplitude of the specified point of the amplitude profile.
Parameters:
<AmplitudeMode>
BPLot:AMPLitude:PROFile:POINt<n>:FREQuency
Sets the frequency of the specified point of the amplitude profile.
Parameters:
<Frequency>
BPLot:AMPLitude:MODE
Sets the amplitude mode.
Parameters:
<AmplitudeMode> CONStant | PROFil
CONStant
In the amplitude constant mode, there is a fixed amplitude for all
frequencies.
Applications