Rohde & Schwarz RTM3K-COM2 - Page 252

Serial bus analysis
R&S
®
RTM3000
252User Manual 1335.9090.02 ─ 09
Remote command:
BUS<b>:TYPE on page 604
Decode
Enables protocol decoding for the selected bus.
Remote command:
BUS<b>:STATe on page 604
Configuration
Opens or closes the dialog box with configuration settings of the selected bus.
The following chapters describe manual protocol configuration:
●
Chapter 15.5, "Parallel buses", on page 397
●
Chapter 13.2.2, "SPI configuration", on page 261
●
Chapter 13.3.2, "I²C configuration", on page 270
●
Chapter 13.4.2, "UART configuration", on page 278
●
Chapter 13.5.2, "CAN configuration", on page 286
●
Chapter 13.6.2, "LIN configuration", on page 300
●
Chapter 13.7.2, "Audio configuration", on page 313
●
Chapter 13.8.2, "MIL-STD-1553 configuration", on page 323
●
Chapter 13.9.2, "ARINC 429 configuration", on page 332
Trigger
Opens the trigger setup for the selected protocol.
The following chapters describe protocol triggering:
●
Chapter 13.2.3, "SPI trigger", on page 264
●
Chapter 13.3.3, "I²C trigger", on page 272
●
Chapter 13.4.3, "UART trigger", on page 281
●
Chapter 13.5.3, "CAN trigger", on page 288
●
Chapter 13.6.3, "LIN trigger", on page 302
●
Chapter 13.7.2, "Audio configuration", on page 313
●
Chapter 13.8.3, "MIL-STD-1553 trigger", on page 325
●
Chapter 13.9.3, "ARINC 429 trigger", on page 334
Triggering on parallel buses is not possible.
Note: Selecting "Trigger" in the protocol menu automatically enables protocol decod-
ing.
Display Setup
Opens a menu to define display settings, e.g. data formats. Display settings are valid
for all protocol types.
See Chapter 13.1.2, "Displaying decode results", on page 253.
Label List
Opens a menu to load and apply a list with symbolic names of addresses or identifiers.
Only available for CAN and LIN.
See Chapter 13.1.5, "Label list", on page 257.
Bus Table
Opens a menu to define bus table settings for the decoded frames of the acquisition.
Basics of protocol analysis