Signal generation (option R&S RTM-B6)
R&S
®
RTM3000
403User Manual 1335.9090.02 ─ 09
The arbitrary waveform is shown in magenta color. If the arbitrary waveform was
created from a part of the displayed channel waveform, this part is stretched in hor-
izontal direction to fill all divisions.
10. To load an existing arbitrary waveform or a saved reference waveform, tap "Load".
Select the waveform file.
11. Tap "Back".
12. Activate "Output" to output the waveform at the [Gen] connector at the front panel.
The created arbitrary waveform is output at the [Gen] connector at the front panel,
with the frequency, amplitude and offset that are set in the "Function Generator"
menu.
To generate an arbitrary waveform using the short menu
Settings are described in Chapter 16.1.6, "Arbitrary setup settings", on page 411.
1. Capture and display the waveform that is the basis for the arbitrary waveform.
2. Press the [Gen] key on the front panel.
3. Select "Function" > "Arbitrary".
4. Set the frequency, amplitude, and offset of the generated waveform.
5. Activate "Output".
6. Open the short menu of the function generator in the bottom menu.
7. Tap "Copy Waveform".
8. To select a sector of the existing waveform, tap "Cut Waveform". Do one of the fol-
lowing:
a) Drag the limit lines of the area to change the start and stop time.
A time edit field is shown, where you also can set the "Start" and "Stop" time.
b) Tap "Set Period" to set the copy to the first period of the waveform.
c) Tap "Set To Screen", to set the copy area within the screen around the trigger
point.
d) Tap "Select All" the use the complete waveform.
9. Press "Copy" to create the arbitrary waveform the "Cut Waveform" limits.
The arbitrary waveform is shown in magenta color. If the arbitrary waveform was
created from a part of the displayed channel waveform, this part is stretched in hor-
izontal direction to fill all divisions. The arbitrary waveform is automatically saved.
The created arbitrary waveform is output at the [Gen] connector at the front panel,
with the frequency, amplitude and offset that are set in the "Function Generator"
menu.
To configure a burst
Burst settings are described in Chapter 16.1.5, "Burst settings", on page 410.
1. Press the [Gen] key on the front panel.
Function generator
To Next Page
Loading...
Need help?
General
