Remote control commands
R&S
®
RTM3000
605User Manual 1335.9090.02 ─ 09
Suffix:
<b>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
BUS<b>:FORMat <Format>
Sets the decoding format for the display on the screen.
Suffix:
<b>
.
1..4
Parameters:
<Format> ASCii | HEXadecimal | BINary | DECimal | OCTal
*RST: HEX
BUS<b>:LABel <Label>
Defines an additional name label for the selected bus. The maximum name length is 8
characters, and only ASCII characters provided on the on-screen keypad can be used.
Suffix:
<b>
.
1..2
Selects the bus.
Parameters:
<Label> String value
BUS<b>:LABel:STATe <State>
Displays or hides the bus label. The bus label is shown on the the right side of the dis-
play.
Suffix:
<b>
.
1..2
Selects the bus.
Parameters:
<State> ON | OFF
*RST: ON
BUS<b>:DSIGnals <BitsSignals>
Displays the individual bit lines above the decoded bus line.
Suffix:
<b>
.
1..4
Serial bus analysis
To Next Page
Loading...
Need help?
General
