Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
690User Manual 1335.9090.02 ─ 09
Suffix:
<b>
.
1..4
Return values:
<WordCount>
Usage: Query only
BUS<b>:MILStd:WORD<n>:COMMand:MCODe:CODE?
For the sepcified command word, returns the type of mode code.
Suffix:
<b>
.
1..4
<n> *
Return values:
<ModeCode> DBControl | TSYNchronize | TSTatus | ISELftest | TSHutdown |
OTSHutdown | ITERminal | OITerminal | RESet | VECTor |
RSYNchronize | TLAStcmmand | BITWord | STSHutdown |
OSTShutdown
DBControl: dynamic bus control.
TSYNchronize: synchronize without data.
TSTatus: transmit status word.
ISELftest: initiate self-test.
TSHutdown: transmitter shutdown.
OTSHutdown: override transmitter shutdown.
ITERminal: inhibit terminal flag bit.
OITerminal: override inhibit terminal flag bit.
RESet: reset remote terminal.
VECTor: transmit vector word.
RSYNchronize: synchronize with data.
TLAStcmmand: transmit last command word.
BITWord: transmit BIT word.
STSHutdown: selected transmitter shutdown.
OSTShutdown: override selected transmitter shutdown.
*RST:
ANY
Usage: Query only
BUS<b>:MILStd:WORD<n>:COMMand:MCODe:VALue?
For the specified command word, returns the value of the mode code.
Suffix:
<b>
.
1..4
<n> *
Return values:
<ModeCodeValue>
Serial bus analysis