Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
728User Manual 1335.9090.02 ─ 09
Return values:
<LevelMinimum>
Usage: Query only
POWer:HARMonics:RESult<n>:RESet
Resets the count of the measurements.
Suffix:
<n>
.
1..40
Usage: Event
POWer:HARMonics:RESult<n>:VALid?
Queries if the value of n-th harmonic is within the limit for the current measurment.
Suffix:
<n>
.
1..40
Return values:
<Valid> PASS | FAIL
Usage: Query only
POWer:HARMonics:RESult<n>:VCOunt?
Queries the number of waveforms, for which the limit value of at least one harmonic
was violated.
Suffix:
<n>
.
1..40
Parameters:
<ViolateCount>
Usage: Query only
POWer:HARMonics:RESult<n>:WFMCount?
Queries the number of waveforms, for which the harmonics were measured.
Suffix:
<n>
.
1..40
Return values:
<WaveformCount>
Usage: Query only
POWer:HARMonics:STANdard <Standard>
Sets a standard for the current harmonic measurement.
Power analysis (option R&S
RTM-K31)