Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
762User Manual 1335.9090.02 ─ 09
POWer:SWITching:GATE:NCONduction:STARt <StartTime>
Sets the start time for the non conduction gate. This value is simultaneously the stop
time for the turn off gate.
Parameters:
<StartTime>
POWer:SWITching:GATE:NCONduction:STOP <StopTime>
Sets the cursor on the waveform.
Parameters:
<StopTime>
POWer:SWITching:GATE:SWAVe
Sets the cursor on the waveform.
Usage:
Event
POWer:SWITching:GATE:TOFF:STARt <StartTime>
Sets the start time for the turn off gate. This value is simultaneously the stop time for
the conduction gate.
Parameters:
<StartTime>
POWer:SWITching:GATE:TOFF:STOP <StopTime>
Sets the stop time for the turn off gate.
Parameters:
<StopTime>
POWer:SWITching:GATE:TON:STARt <StartTime>
Sets the start time for the turn on gate.
Parameters:
<StartTime>
POWer:SWITching:GATE:TON:STOP <StopTime>
Sets the stop time for the turn on gate.
Parameters:
<StopTime>
Power analysis (option R&S RTM-K31)