Operation
Lifter
257 / 564
The correct setting of the rollers movement height fulfills two purposes:
Ensuring optimum beet flow. We recommend to have shaft movement always as
high as possible above ground. The maximum height has just been exceeded,
when, during lifting, the beet flow falters from the lifting shares to the first lifting
roller.
Guiding of the lifting rollers at the correct height. In case of soil of different hard-
ness, the height adjustment of the depth-control shaft is able to balance out sinking
in of the depth-control shaft into the soil to different depths. The lifting rollers should
be guided above the soil at always the same height, which is no longer ensured for
differing sinking in of the depth-control shaft.
Rollers movement height is displayed on the R-Touch.
Height adjustment of shaft movement is performed by diagonal pushing or pulling of
the X-Y key (5) on the joystick.
If the X-Y key is touched briefly, the adjustment will be performed gradually by one
step up or down.
To directly adjust for several stages at once, the X-Y key may be moved to the
required position and held for so long until the desired setting has been reached.
The X-Y key (5) is programmed for the following dual function: when pressing the X-Y
key (5) if the multi-key (11) is pressed, the rollers movement height is adjusted simulta-
neously on both sides, regardless of to which side the X-Y key is moved.
To Next Page
Loading...