Lists/Tables/Plans/Diagrams/Maintenance Verification
Maintenance table
533 / 564
Maintenance interval
Maintenance work
before har-
vest
start
daily
after the
first 50
oper. hrs.
every 50
oper. hrs.
after the
first 500
oper. hrs.
every 500
oper. hrs.
when
needed
annu-
ally
Driver's cabin
Clean recirculating air filter X
Replace recirculating filter X
Clean fresh air intake filter X X
Renew fresh air intake filter X
Defoliator
Grind scalper flails As required: once daily to once weekly
Retighten flail fastening defoliator shaft after the first 10 lifting hours
Lifter
Check oil level at all lifter gears X X
Change oil at all lifter gears X X X
Check depth-control roller gear oil level X X
Change depth-control roller gear oil X X X
Check oil level shaking share drive X X
Change oil shaking share drive X X X
Eccentric shaft bearing oil level control X X
Check oil level paddle gears X X
Paddle gears oil exchange X X X
Infeed conveyor
Check gear oil level X X
Change gear oil X X X
Check front guide rollers condition X
Strainer wheels
Retighten strain wheel prongs X X X
Adjust or replace scraper X
To Next Page
Loading...