Siemens Hipath 5000 - Page 1098

Codes for Activating/Deactivating Features
P31003-H3560-S403-54-7620, 09/05
B-8 HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
fcodes.fm
Change tele-
phone lock ac-
cess code
*93+Old
code+2 x New
code
7593... *93... – – – H Local
feature
menu
Local
feature
menu
AN,
DIG,
ENT,
S0,
CMI,
IPSC
X RK,
BS
Reset servic-
es/features for
own workpoint
client
#0 760 #0 – – – H – Fea-
ture key
AN,
DIG,
ENT,
S0,
CMI,
IPSC
x RK,
BS
See feature de-
scription: Reset
activated features
Speaker calls *80+Stn. no. 7580 *80 – V, U – H Menu Fea-
ture key
AN,
DIG,
ENT,
S0,
CMI,
IPSC
– RK,
BS.
WA,
RG
Speaker calls to a
group: Paging only
possible if “Speak-
er call” has been
enabled for the
called party. The
called party’s mi-
crophone is acti-
vated if “Direct An-
swering” has been
enabled for this
party (not for pag-
ing).
Hands free an-
swerback on
– – *96 – V, T RH U1 – – DIG,
CMI,
IPSC
X – Only for WpC with
speakerphone
Hands free an-
swerback off
– – #96 – V, T RH U1 – – DIG,
CMI,
IPSC
X – Only for WpC with
speakerphone
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Sup-
ported
work-
point
clients
(see
abbre-
via-
tions
in
Table
B-1)
Locking of
feature
Note
TDM workpoint
clients without
display,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients,
optiClient 130 V5.0 phone
optiCli-
ent 130
V5.0
easy-
Com
optiCli-
ent 130
V5.0
office
Code +
procedure
Code Code
Key Menu
Code Code
via
lock code
Status
locking on
Fixed
Programmable
bar
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu