service.fm
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
12-11
Service
Service and Maintenance Tasks
12.2.3 Relocate/Transfer Application Processor Software (APS)
For system software updates, a distinction is made between
● HiPath 3000 systems without HiPath Software Manager and
● HiPath 3000 systems with HiPath Software Manager.
For networked HiPath 3000 systems with HiPath 5000 RSM, an APS update can only be per-
formed with HiPath Software Manager.
12.2.3.1 APS Replacement/Transfer for HiPath 3000 Systems Without HiPath
Software Manager
Two memory areas are reserved for the application processor software on the MMC. To be able
to store two complete APS and to keep the transfer time as low as possible, part of an APS is
stored in a compressed format. The APS is decompressed after it has been transferred from
the MMC to the SDRAM area of the central control board.
12.2.3.1.1 Transferring an APS of HiPath 3000 by Replacing the MMC
Procedure
>
APS replacement/transfer is not possible with HiPath 5000. You must perform a
complete software upgrade.
>
APS replacement is only possible within a version and if a logical, compatible CDB
is available.
Step Activity
1. Create a backup of the current CDB and save on a customer disk for security
reasons.
2. Remove MMC with “old” APS.
The flashing Run LED (0.1 s on/0.1 s off) indicates that the MMC is missing.
The system remains active for call processing.
3. Install new MMC with “new” APS.
The system creates an automatic CDB backup and thus saves the current cus-
tomer database (CDB) to the new MMC.
4. An automatic reset is then performed (hard restart for entire system with the
current CDB).
To Next Page
Loading...
Need help?
General