boards.fm
P31003-H3560-S403-54-7620, 09/05
HiPath 3000 V6.0, HiPath 5000 V6.0, Provisional Service Manual
3-35
Boards for HiPath 3000
Central Boards
3.2.4 CBSAP
Introduction
The CBSAP board (Central Board Synergy Access Platform) performs all central control and
switching functions for HiPath 3800 (see Figure 3-4).
Subboards
The following subboards can be used depending on the application:
● CMS clock module (optional)
● MMC multimedia card
● IMODN integrated modem card new (optional)
● LIMS LAN interface module (optional)
Contains two Ethernet (10BaseT) LAN connectors (8-pin RJ45 jacks):
– LAN1 (administration via HiPath 3000 Manager E and CTI functions)
– LAN2 (not assigned)
● MPPI music on hold (optional)
V.24 interfaces (9-pin SUB-D plug)
● Service (X50) = for connecting the service PC
● Application (X51) = for connecting a printer or application
Switches and indicators
● Reset/reload switch:
– Switch pressed < 5 s = Reset activated
– Switch pressed > 5 s = Reload activated (Fail LED (red) out indicates that a reload is
in progress).
● Two LEDs indicating the board status:
– Run (green) = signals the current status of the CBSAP board (see Table 12-2)
– Fail (red) = error encountered
To Next Page
Loading...
Need help?
General