Figure 5-57: Model 1204-3E option card rear plate
If the unit is ON, verify that the BURST lamp is blinking.
If the unit is OFF, turn it on, and wait until the BURST lamp is blinking.
If the BURST lamp is not blinking after the subscription has been activated, the STL receiver
is not receiving an STL signal. Check the antenna cable and its connections, and the
antenna location. Move the antenna to another location (higher or closer to an outside
wall).
R e a r P l a t e L E D s :
BURST: Indicates the incoming STL burst rate. A high burst rate (desired) is indicated by the
LED flashing quickly.
PPS: Indicates that the STLreceiver is sending out a PPS signal to SecureSync. One (1) pulse
per second means that the receiver is locked. NOTE: It can take approximately 10 minutes or
longer until the receiver is locked. This depends on the burst rate (see "Burst Rate" on
page493.)
Both LEDs have equivalent indicators in the Web UI STL 0 status window:
488 SecureSync User Reference Guide
APPENDIX
To Next Page
Loading...
