6.
Proceed with the SW configuration of the STL settings, as described below.
Note: The RJ-45 MAINT. connector will not be needed for the STL con-
figuration. Use this connector only if so requested by Spectracom Service
personnel.
Configuring STL Settings
Note: If you do not yet have a subscription key, you will need to obtain one
before continuing with installation. Please contact Orolia customer service:
stlsubscription@orolia.com
US: +1 585 321 5800; France: +33 (0)1 64 53 3980
Note: During the initial installation of a unit equipped with an STL card, the exact
geographic position needs to be entered into the Web UI (see below). Should the
unit be relocated at a later point in time, the position must be changed accord-
ingly.
The STL option card 1204-3E is configured via the SecureSync WebUI. See "The SecureSync
Web UI" on page18 for basic SecureSync setup and initial login information.
SecureSync User Reference Guide 489
APPENDIX
To Next Page
Loading...
