Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 101
Chapter 3
TimeProvider 5000 CLI Command Set
|78 |minor |0 |enable |GNSS/GPS signal low
|....|.........|.......|........|.............................................
|79 |event |0 |enable |PTP client dropped from client list
|....|.........|.......|........|.............................................
|80 |event |0 |enable |PTP client added to client list
|....|.........|.......|........|.............................................
|81 |event |0 |enable |PTP client IP address to be changed
|....|.........|.......|........|.............................................
|82 |event |0 |enable |PTP client changed to new IP address
|....|.........|.......|........|.............................................
|83 |event |0 |enable |PTP client list refreshed
|....|.........|.......|........|.............................................
|84 |critical |0 |enable |FPGA in failed state
|....|.........|.......|........|.............................................
|85 |event |0 |enable |PTP port state changed to master
|....|.........|.......|........|.............................................
|86 |event |0 |enable |PTP port state changed to passive
|....|.........|.......|........|.............................................
|87 |event |0 |enable |PTP port state changed to listening
|....|.........|.......|........|.............................................
|88 |event |0 |enable |PTP port state changed to disabled
|....|.........|.......|........|.............................................
|89 |major |0 |enable |DTI input port lost of signal
|....|.........|.......|........|.............................................
|90 |major |0 |enable |DTI input port invalid
|....|.........|.......|........|.............................................
|91 |event |0 |enable |DTI input port active
|....|.........|.......|........|.............................................
|92 |event |0 |enable |EXP connected
|....|.........|.......|........|.............................................
|93 |event |0 |enable |EXP disconnected
|....|.........|.......|........|.............................................
|94 |event |0 |enable |Shelf ID changed
|....|.........|.......|........|.............................................
|95 |minor |0 |enable |Exp-Interface link down
|....|.........|.......|........|.............................................
|96 |major |0 |enable |EXP has duplicated shelf ID
|....|.........|.......|........|.............................................
|97 |minor |0 |enable |IMC-EXP Software incompatible
|....|.........|.......|........|.............................................
|98 |event |0 |enable |GNSS receiver change track mode
|....|.........|.......|........|.............................................
|99 |minor |0 |enable |Fan failure
|....|.........|.......|........|.............................................
|100 |major |0 |enable |Multiple fans failure
|....|.........|.......|........|.............................................
|101 |major |0 |enable |PPS-TOD input communication error
|....|.........|.......|........|.............................................
|102 |minor |0 |enable |PPS-TOD input unusable
|....|.........|.......|........|.............................................
|103 |minor |0 |enable |Time and phase questionable
|....|.........|.......|........|...............................................|
|104 |minor |0 |enable |NTP server near packet limit
------------------------------------------------------------------------------
Level : User, Config, and Admin

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English