Symmetricom TimeProvider 5000 User Manual

124 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show exp-if config
Use this command to display the configurations of DTI and Ethernet port on IMC
and IO cards and expansion shelves.
Command Syntax:
show exp-if config {imc | io | exp[0-9]}
Example 1:
To display the
tp5000> show exp-if config imc
Response 1:
To display the configurations of DTI and Ethernet on the IMC expansion port
imc-exp eth state: enable
imc-exp dti state: enable
Example 2:
To display the configurations of DTI and Ethernet on the IO expansion port
tp5000> show exp-if config io
Response 2:
io-exp-1 state: enable
io-exp-2 state: enable
Example 3:
To display the configurations of DTI and Ethernet on expansion shelf 1 (id= 0)
expansion port
tp5000> show exp-if config exp0
Response 3:
EXP-DTI in1 state : enable
EXP-DTI in2 state : enable
Level : User, Config and Admin

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English