Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 127
Chapter 3
TimeProvider 5000 CLI Command Set
set exp-if dti
Use this command to enable or disable the DTI port between the IMC and
expansion shelf, or the DTI ports in expansion shelf. that is used to connect to an
expansion shelf. This command is typically used to disable the DTI port when there
are no expansion shelves being used with the TP5000.
Command Syntax:
set exp-if dti {imc-exp | io-exp-1 | io-exp-2 |
{exp[0-9] {in1|in2}}} {enable | disable}
Example 1:
To disable the DTI interface IN 1 port on expansion shelf ID=2 -
tp5000> set exp-if dti exp2 in1 disable
Example 2:
To enable the DTI interface port on the IMC card -
tp5000> set exp-if dti imc-exp enable
Example 3:
To enable the DTI interface port 1 on the IO card -
tp5000> set exp-if dti io-exp-1 enable
Remark : The imc-exp is the DTI port located on the IMC card. The dti-exp-1
and
dti-exp-2 are the DTI ports located on the IO module. The exp[0-9] in1 and
exp[0-9] in2 are the DTI IN 1 and DTI IN 2 ports located on the expansion
shelves.
Level : Config, and Admin

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English