136 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show gps
This command displays the position (latitude, longitude, height), elevation mask
value (positioning filter), mode of operation (manual or automatic), and GPS
satellite tracking status. It also displays information for all satellite vehicles being
tracked: vehicle number, health, noise ratio, satellite elevation, satellite azimuth.
Command Syntax:
To display the GPS configuration on the GPS port:
show gps config
To display the GPS status on the GPS port:
show gps status
Example 1:
tp5000>show GPS config
Response 1:
GPS Configuration
State - enable
Priority - 2
Mode - auto
Mask - 10
Antenna Delay - 0
PQL State - disable
PQL Value - 1
GPS manual position
Latitude - N37:22:43.425
Longitude - W121:55:34.815
Height - 13.7
Example 2:
tp5000>show gps status
Response 2:
GPS Status