Symmetricom TimeProvider 5000 User Manual

138 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
set gps
Use this command to provision the GPS port for mode of operation, position, and
positioning elevation mask. With this command, you can provision the GPS to use
either automatic or manual mode to determine the system’s position. You can
provision the GPS position if the system is provisioned for Manual mode of
operation. You can also provision the elevation mask to provide a method of filtering
satellites to be used by the system.
Command Syntax:
 To set the GPS mode
set gps mode {auto|manual} [latitude <lat-value> longitude
<lon-value> height<height-value>]
– Position can only be provisioned manually when GPS mode is “manual”.
Where
Latitude is in the format N|Sddd:mm:ss.sss, for example:
N37:22:45.123
S48:33:67.456
Longitude is in the format E|Wddd:mm:ss.sss, for example:
W121:55:36.123
E157:33:47.456
Height is in meters with one digit after the decimal point, for
example:
17.5
 To enable or disable GPS
set gps state {enable|disable}
 To set the GPS priority
set gps priority <priority-value>
 To set the GPS mask value
Note: Latitude and Longitude are entered as pddd:mm:ss.sss, where
p is N or S for latitude and E or W for longitude, ddd is degrees, mm is
minutes, and ss.sss is seconds. For example: N59:20:3.458 or
W121:31:42.69. Height is in meters, with a range of -999.9 to 40000.0
meters
Note: Symmetricom recommends that the Auto mode be used. Any
error in the manually-specified system position will generate timing
errors.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English