Symmetricom TimeProvider 5000 User Manual

156 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
show ioc-state
This command displays the state of both the active and standby IOC module. If either
IOC module cannot assume the active or standby state, the state indicates NOT
AVAILABLE.
Command Syntax:
show ioc-state
Example:
tp5000> show ioc-state
Response:
---------------------------------
|Module ID |State |
|---------------|---------------|
|ioc1 |active |
|...............|...............|
|ioc2 |standby |
---------------------------------
Level : User, Config, and Admin
set ioc-state
Use this command to provision the standby module to become the active module.
IOC1 refers the
IOC module to the left of the IMC and IOC2 refers to the IOC module
to the right of the IMC.
Command Syntax:
set ioc-state {ioc1 | ioc2} active
Example:
tp5000> set ioc-state ioc2 active
Remarks :
Switchover to the standby IOC will be prohibited if the standby IOC has alarms of
higher severity than the active IOC, or if the standby IOC is still in warm-up. Check
system status and alarms if the command fails.
Level : Config and Admin only

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English