182 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
Command Syntax:
To provision the state for the specified output port:
set output state {port1|port2|port3|port4} {enable|disable}
To provision the output frame type:
set output frametype {port1|port2|port3|port4}
{ccs|cas|freq2048khz|d4|esf|freq1544khz}
To provision the CRC output:
set output crc {port1|port2|port3|port4} {enable|disable}
To provision the SSM output:
set output ssm {port1|port2|port3|port4} {enable|disable}
To provision the output ssm-bit:
set output ssm-bit {port1|port2|port3|port4} [4 thru 8]
To provision the output behavior during the warm-up state:
set output warm-up {port1|port2|port3|port4}
{on|squelch|ais}
To provision the output behavior during the free-run state:
set output free-run {port1|port2|port3|port4}
{on|squelch|ais}
To provision the output behavior during the holdover state:
set output holdover {port1|port2|port3|port4}
{on|squelch|ais}
Bridging Last PQL of reference
Holdover PQL of oscillator
Note: The default output frame type is freq2048khz.
Note: The T1 isolated pulse mode has precedence over other
frame types. This setting is not stored in non-volatile memory.
Clock State Output SSM
To Next Page
Loading...
Need help?
General
