Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 185
Chapter 3
TimeProvider 5000 CLI Command Set
show output-10m-config
This command displays the System's 10 MHz Output Port state, as well as the
provisioned behavior of the 10 MHz Output Port during the warm-up, free-run, and
holdover states.
Command Syntax:
show output-10m-config
Example:
tp5000> show output-10m-config
Response:
10MHz output configuration:
Port status - enable
10MHz generation warm-up - squelch
10MHz generation free-run - squelch
10MHz generation fast-track - on
10MHz generation holdover - on
Level : User, Config, and Admin
set output-10m
Use this command to provision the System's 10 MHz Output Port state. It is also
used to provision the behavior of the 10 MHz Output Port during the warm-up,
free-run, and holdover states.
Command Syntax:
 To provision the state of the the 10 MHz output port:
set output-10m state [enable|disable]
 To provision the output behavior during the warm-up state:
set output-10m warm-up {on|squelch}
 To provision the output behavior during the free-run state:
set output-10m free-run {on|squelch}
 To provision the output behavior during the fast-track state:
set output-10m fast-track {on|squelch}
 To provision the output behavior during the holdover state:

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English