Symmetricom TimeProvider 5000 User Manual

208 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
where
y= 1|2, the port number
 To set the PTP unicast dynamic maximum lease duration value:
set ptp unicast dynamic lease-duration {ioc1-1 | ioc1-2}
<lease-duration value>
Unicast Specific Attributes - Static:
 To provision the state for the specified IOC module and port in PTP Unicast static
mode:
set ptp unicast static state {ioc1-1 | ioc1-2} index [1 - 10]
[enable|disable]
where
index = client number.
 To set the PTP Unicast static IP address:
set ptp unicast static address {ioc1-1 | ioc1-2}
{add|remove} index [1 - 10] address <IP-address>
 To provision the PTP Unicast static clock ID:
set ptp unicast static clockid {ioc1-1 | ioc1-2} index [1 -
10] <clock-id>
where the Clock ID is in the form xx:xx:xx:xx:xx:xx:xx:xx
 To set the PTP Unicast static VLAN ID:
set ptp unicast static vlanid {ioc1-1 | ioc1-2} index [1 -
10] <VLAN-ID>
 To set the interval between synchronization messages for PTP Unicast static:
set ptp unicast static sync-int {ioc1-1 | ioc1-2}
index [1 - 10] <sync-int-value>
– The interval is 2
z
seconds, where z= <sync-int-value>.
 To set the interval between announce messages for PTP Unicast static:
set ptp unicast static announce-int {ioc1-1 | ioc1-2}
index [1 - 10] <announce-int-value
>
Note: The VLAN must be configured with the set vlan
command.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English