Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 207
Chapter 3
TimeProvider 5000 CLI Command Set
Multicast Specific Attributes - TP 5000:
 To provision the PTP Multicast client timeout value:
set ptp multicast client-timeout {ioc1-1 | ioc1-2 |
exp[0-9]} <timeout-value>
 To provision the PTP Multicast announce timeout value:
set ptp multicast announce-timeout {ioc1-1 | ioc1-2 |
exp[0-9] port<1-16>} <timeout-value>
where
y= 1|2, the port number
 To provision the PTP Multicast VLAN ID:
set ptp multicast vlanid {ioc1-1 | ioc1-2} <vlanid-value>
 To provision the interval between announce messages for PTP Multicast:
set ptp multicast announce-int {ioc1-1 | ioc1-2 | exp[0-9]
port<1-16>} <announce-int-value>
– The interval is 2
z
seconds, where z= <announce-int-value>.
 To provision the interval between synchronization messages for PTP Multicast:
set ptp multicast sync-int {ioc1-1 | ioc1-2 | exp[0-9]
port<1-16>} <sync-int-value>
– The interval is 2
z
seconds, where z= <sync-int-value>.
 To provision the interval between delay response messages for PTP Multicast:
set ptp multicast delay-int {ioc1-1 | ioc1-2 | exp[0-9]
port<1-16>} <delay-int-value>
– The interval is 2
z
seconds, where z= <sync-int-value>.
Unicast Specific Attributes – Non-Fixed:
 To provision the PTP unicast dynamic negotiation state:
set ptp unicast dynamic negotiate {ioc1-1 | ioc1-2}
{enable|disable}
Note: The VLAN must be configured with the set vlan command.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English