Symmetricom TimeProvider 5000 User Manual

210 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
Example 1  Common Attributes:
To set the PTP profile for port 1 of IOC1 to hybrid:
tp5000> set ptp profile ioc1-1 hybrid
Example 2
 Common Attributes:
To set the PTP profile for port 2 of IOC1 to Telecom-2008 (unicast):
tp5000> set ptp profile ioc1-1 telecom-2008
Example 3
 Common Attributes:
To set the maximum number of clients to “100” for port 1 of IOC1:
tp5000> set ptp max-client ioc1-1 100
Example 4
 Common Attributes:
To set the timescale for IOC1 to PTP:
tp5000> set ptp timescale ioc1 ptp
Example 5
 Common Attributes:
To Enable the alternate master mode for IOC1:
tp5000> set ptp alternative-master ioc1 enable
Example 6
 Common Attributes:
To Enable port 1 of IOC1 for PTP:
Note: See Factory Defaults, on page 448 in Appendix B for defaults
values and ranges for PTP parameters.
Note: Management addressing mode controls whether PTP
management messages use Multicast or Unicast. This is independent
of the set ptp profile command. For example, management
addressing can be set for Multicast while PTP synchronization is
using the Telecom-2008 (Unicast). For multicast management, the
client must be in the TP5000's client list.
Note: If the Alternate Master mode is set to Enable, the alternate
master flag will be set in the PTP messages.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English