Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 215
Chapter 3
TimeProvider 5000 CLI Command Set
show ptp client
Use this command to display the PTP client attributes:
Command Syntax:
 To display the attributes for the specified PTP client for the specified PTP port :
show ptp client ioc-[y] address <ip-address>
 To display the attributes for all PTP clients for the specified PTP port :
show ptp client { ioc-1 | ioc-2 | exp[0-9] port <1-16>} all
Example 1:
To show the PTP client attributes for the client on port 1 of the active IOC module at
IP address 192.168.5.132:
tp5000> show ptp client ioc-1 address 192.168.5.33
Response 1:
IP Address VLAN PRI Clock Id Mode Ann Sync Delay
192.168.5.33 0 0 00:B0:AE:FF:FE:01:1A:85 D 0 0 -6
Example 2:
To show the PTP client attributes for all clients on port 1 of the active IOC module:
tp5000> show ptp client ioc-1 all
Response 2:
IP Address VLAN PRI Clock Id Mode Ann Sync Delay
Note: The TP5000 uses a proprietary technique to create a list of
clients in the multicast mode. A maximum of 500 clients can be
added to the list.
In multicast mode, the TP5000 creates a client list by examining the
received PTP delay request messages. In order for a client to be
reliably added to the client list and not removed, the TP5000 needs to
receive several hundred delay request messages during the client
timeout period. If delay requests are sent at a slow rate, then the
client-timeout value must be increased. Since one-way PTP
operation does not use delay request and delay response messages,
the client list will not be populated in this mode.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English