Symmetricom TimeProvider 5000 User Manual

216 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
192.168.5.13 0 0 00:B0:AE:FF:FE:01:1A:85 D 0 0 -6
192.168.5.23 0 0 00:B0:AE:FF:FE:01:1B:85 D 0 0 -6
192.168.5.33 0 0 00:B0:AE:FF:FE:01:1C:85 D 0 0 -6
Example 3:
To show the PTP client attributes for all clients on port 10 of the expansion shelf
ID=9, and the PTP is in L2 mode:
tp5000> show ptp client exp9 port 10 all
Response 3:
IP Address VLAN PRI Clock Id Mode Ann Sync Delay
0.0.0.0 0 0 00:B0:AE:FF:FE:01:1A:85 D 0 0 -6
0.0.0.0 0 0 00:B0:AE:FF:FE:01:1B:85 D 0 0 -6
0.0.0.0 0 0 00:B0:AE:FF:FE:01:1C:85 D 0 0 -6
Level : Config and Admin only
set ptp client-disconnect
Use this command to disconnect a PTP client using its clock ID,
Command Syntax:
set ptp client-disconnect ioc-[x] <client-clock-ID-value>
Example:
To disconnect the PTP client on IOC1-1 with clock ID value of
0A:11:22:33:44:55:66:77:
tp5000> set ptp client-disconnect ioc-1
0A:11:22:33:44:55:66:77
Level : Config and Admin
Note: Only Ethernet L2 is supported in expansion shelves until future
release, and the IP address field is filled as 0.0.0.0

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English