EasyManuals Logo

Symmetricom TimeProvider 5000 User Manual

Symmetricom TimeProvider 5000
534 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #242 background imageLoading...
Page #242 background image
242 TimeProvider 5000 Users Guide 098-00028-000 Revision F – May, 2012
Chapter 3
TimeProvider 5000 CLI Command Set
To provision the state of SNMP v2 communities:
set snmp state-v2 {enable | disable}
To set the SNMP sys-obj MIB version to either 1.2 or 2.0:
set snmp sys-obj-mib {1.2 | 2.0}
To set the SNMP trap MIB version to either 1.2 or 2.0:
set snmp trap-mib {1.2 | 2.0}
Example 1:
To add SNMP user named “maynard”, with a security level of “priv”:
tp5000> set snmp add user maynard securelvl priv
Response 1:
For security level of priv, the TP5000 will prompt for:
Authentication protocol (MD5 or SHA):
Authentication key [Only chars {a-z,A-Z,0-9,! ( )- _ . ? ~ * @ ^ +
= : / %} are accepted] :
Privacy protocol (DES or AES):
Privacy key [Only chars {a-z,A-Z,0-9,! ( )- _ . ? ~ * @ ^ + = : / %}
are accepted]:
If the security level is auth, the TP5000 will prompt for:
authkey <authkey-value>
authtype {MD5 | SHA}
Example 2:
To add SNMP v2-community named “groupv2”, with a security level of read-write:
tp5000> set snmp add v2-community groupv2 securelvl
read-write
Example 3:
To add SNMP manager with the IP address 192.168.5.177 and engine ID of
0x12345678901234:
set snmp add manager 192.168.5.177 engineid 0x12345678901234
Example 4:
To delete SNMP trap user named “george3”:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 5000 and is the answer not in the manual?

Symmetricom TimeProvider 5000 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 5000
CategoryServer
LanguageEnglish

Related product manuals