Symmetricom TimeProvider 5000 User Manual

410 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Appendix A System Messages
System Notification Messages
GNSS/GPS
antenna
open-circuit
(See Table A-2 for
Secondary Index Info)
IMC 13 Minor No GNSS/GPS antenna
open-circuit
GNSS/GPS antenna
open- circuit cleared
Check all cable and
antenna
connections, check
voltage suppressor
None required
Battery(-48V)-A
failure
IMC
EXPx
x = 09
14 Major No Battery (-48V) -A
failure
Battery (-48V) -A
failure cleared
Troubleshoot the
-48V power supply.
Check voltage
supply to A side of
shelf
None required
Battery(-48V)-B
failure
IMC
EXPx
x = 09
15 Major No Battery (-48V) -B
failure
Battery (-48V) -B
failure cleared
Troubleshoot the
-48V power supply.
Check voltage
supply to B side of
shelf
None required
FPGA access
failure
IMC
IOC1
IOC2
EXPx
x = 09
16 Critical No FPGA access failure
FPGA access failure
cleared
Hardware fault
-Replace module
None required
Flash partition
failure
(See Table A-2 for
Secondary Index Info)
IMC
IOC1
IOC2
EXPx
x = 09
17 Critical No Flash partition
failure
Flash partition
failure cleared
Hardware fault
-Replace module
None required
Phase-lock-loop
(PLL) unlock error
IMC 18 Critical No PLL unlock error
PLL unlock error
cleared
Reboot System - If
alarm remains,
replace module
None required
Table A-1. System Notification Messages (Continued)
Description
Comp
ID
Event
ID
MsgLevel
Trans-
itory
MsgText Corrective Action

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English