Symmetricom TimeProvider 5000 User Manual

424 TimeProvider 5000 User’s Guide 098-00028-000 Revision F – May, 2012
Appendix A System Messages
System Notification Messages
3 System time invalid
0 - 1 0=Time , 1=Freq
4 System time has been set by
reference
0 - 4 0=GPS, 1=SYS, 2=GNSS,
3=PPS_TOD-1,
4=PPS_TOD-2
5 System log time has been
updated
n/a n/a
6 Management port link down
n/a n/a
7 Ethernet port (ETH1 or ETH2) link
down
0 - 1 0=ETH1, 1=ETH2
8 Manual sync IOC time to IMC
required
n/a n/a
9 Power out of range
0 - 5 * index is internal code
10 GNSS/GPS antenna voltage out
of range
n/a n/a
11 GNSS/GPS antenna current out
of range
n/a n/a
12 GNSS/GPS antenna short-circuit
0 - 1 0=GPS, 1=GNSS
13 GNSS/GPS antenna open-circuit
0 - 1 0=GPS, 1=GNSS
14 Battery(-48V)-A failure
n/a n/a
15 Battery(-48V)-B failure
n/a n/a
16 FPGA access failure
n/a n/a
17 Flash partition failure
0 - 3 * index is internal code
18 PLL unlock error
n/a n/a
19 Internal communication error
0 - 2 * index is internal code
20 FPGA temperature exceed limit
n/a n/a
21 IOC detected but none of them
active
n/a n/a
22 Module reboot
n/a n/a
23 RTE communication to peer error
n/a n/a
24 Entered warmup mode
n/a n/a
25 Entered freerun mode
n/a n/a
Table A-2. Secondary Index Descriptions for System Notification Messages
Event
ID
Description
Secondary
Index
Secondary Index
Description

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English