Rawson controller setup 5 Implement application controller setup
Default Rate
On the CFX-750 display, set the same target rate that displays on the Rawson controller when you
first power up it up. Enter a number between 0 - 9999000.
Step Size
The step size increases or decreases the actual applied rate by the percentage that you select. You
can choose from:
l 2%
l 4%
l 6 2/3%
Rate Snapping
Due to pump constraints, liquid flow is generally inconsistent. To control how these inconsistencies
show up on your display, turn rate snapping on or off.
Setting Explanation
On Matches the actual applied rate to the target rate when within 10%
of the value.
Off Shows all fluctuations in the actual applied rate.
Version 7.0, Revision A CFX-750 Display User Guide 101
To Next Page
Loading...
