Trimble CFX-750 - Vaderstad controller setup; Advanced; Boom Setup

5 Implement application controller setup Vaderstad controller setup
Vaderstad controller setup
1. After you select Vaderstad as your controller, the Output Port screen displays.
2.
Choose the port you want to configure.
Note – Do not configure the display to output NMEA messages on the same port that your
controller is connected to.
3. At the Device Type screen, select the type of implement you are using:
ll Sprayer
l Planter/Seeder
l Fertilizer/Spreader
4. On the Vaderstad controller, go to the setup screen. Set GNSS to No.
Advanced
Use the Advanced option at the Implement screen to set up:
l Boom Setup
l Swath Control
l Rate Control
l Target Rate
l Single section boom switching
l Rate Snapping
Boom Setup
The boom setup on the CFX-750 display must match the setup on the LH 5000 controller. If the
boom setup differs between the display and the Vaderstad controller, a warning message displays.
Setting Explanation
Implement width Enter a width between 1' 00" - 328' 01" (0.30 - 99.99 m).
Fence Nozzles Enter the locations of any fence nozzles.
Number of sections Enter a number between 1 - 10.
108 CFX-750 Display User Guide Version 7.0, Revision A