Trimble CFX-750 - Control setup for a location

Control setup for a location 6 Field-IQ crop input control setup
Operation Settings Explanation
Jump Start Speed The speed that the control system will use when the master
switch is held in the Jump Start Position.
The Rate Switch has to be in Position 1 or 2 for the Jump Start
Feature to work.
Shutoff Speed The system will shut down if the vehicle drops below this speed.
Minimum Override Speed The system will continue to run at this speed if the vehicle drops
below this speed.
Apply Latency to
Boundary
ll Yes: The system starts when needed to begin applying
immediately when crossing a boundary.
l No: The system starts when the boundary is reached and
any mechanical delay could leave a gap between the
boundary and where the product is applied. When GNSS
accuracy is low, this is the preferred selection.
This setting only applies to fields that have a boundary.
This setting is also applied when you exit an exclusion zone and
return to the workable area of the field.
Rate Snap
ll Enabled: Shows the Applied Rate the same as the Target
Rate when the Applied Rate is within 10% of the Target Rate.
l Off: Shows the actual Applied Rate.
8.
After you complete all the Material Type options, tap to return to the Material Setup
screen.
9.
At the Operation Setup screen after you tap , the setup of this material is complete. The
Material Setup screen now shows New Material and Delete All buttons and a list of the
materials you have set up.
Control setup for a location
1. At the Implement screen, tap Control Setup.
2. At the Control Setup screen, tap the location button for the location you want to set up. If this
is the first time that you are completing a control setup, there will be one button only:
Unassigned.
Version 7.0, Revision A CFX-750 Display User Guide 127