5 Implement application controller setup Amazone controller setup
Amazone controller setup
1. After you select Amazone as your controller, the Output Port screen displays.
2.
Choose the port you want to configure.
Note – Do not configure the display to output NMEA messages on the same port that your
controller is connected to.
1. On the Amazone controller, go to the Settings menu.
2. Change Remote to Enable.
For more information on setting up the Amazone controller, refer to the Amazone instruction
manual.
Advanced
Use the Advanced option in the Implement screen to set up:
l Boom Setup
l Swath Control
l Rate Control
l Target Rate
l Turn Off Rate on Overlap
l Rate Snapping
Boom Setup
The boom setup on the CFX-750 display must match the setup on the Amazone controller. If the
boom setup differs between the display and the Amazone controller, a warning message displays.
Setting Explanation
Implement width Enter a width between 1' 00" - 328' 01" (0.30 - 99.99 m).
Fence Nozzles Enter the locations of any fence nozzles.
Number of sections Enter a number between 1 - 10.
102 CFX-750 Display User Guide Version 7.0, Revision A
To Next Page
Loading...
