6 Field-IQ crop input control setup Calibrations
After the Field-IQsetup is complete, the display tests the hydraulics of your system. During this test
you must run the motor(s) at the minimum and maximum RPM and make sure the motor(s)
achieve these RPM.
Calibrations
After the hydraulics test is complete, the display calibrates your system. The available calibrations
are:
l Field-IQ Rawson Control Module
l Servo Pump or PWM Pump
l Pressure Sensors
l Implement Lift Switch
When the calibration is complete, save the data to a configuration file and export it to the USB drive.
See USB drive data transfer, 182.
140 CFX-750 Display User Guide Version 7.0, Revision A
To Next Page
Loading...
