Auto steering system operation 13 Operations
Vehicle Type Performance Suggestion
Sprayer It is common for these vehicles to have slow steering. To compensate for this,
use high aggressiveness.
If you experience large, slow oscillations, increase the aggressiveness.
When you configure the system on a sprayer, the sprayer steering delay
setting is available on the Vehicle Setup screen.
Some sprayers have steering that is slow to react after you turn the steering
wheel. The system uses the steering delay setting to compensate for this
slowness and ensure that steering corrections occur at the correct point.
Swather When you configure the system on a swather, the Swather steering delay
setting is available on the Vehicle Setup screen.
Some swathers have steering that is slow to react after the steering wheel is
turned. The system uses the steering delay setting to compensate for this
slowness and ensure that steering corrections occur at the correct point.
To improve the performance of your swather, adjust the Swather steering
delay setting by a small amount (0.1 seconds) at a time. Test the result
between each adjustment.
After using the EZ-Steer system
Any time that you are not using the EZ-Steer system, pivot the EZ-Steer motor away from the
steering wheel.
Before you leave the vehicle, turn off the EZ-Steer system power switch or remove the power plug.
EZ-Pilot system operation
CAUTION – Do not operate the EZ-Pilot system while driving in reverse gear.
Engage the system
Note – Before you can engage the EZ-Pilot system, you must:
l Set up and calibrate the system.
l Open a field in the Guidance screen.
l Map an AB line.
l Position the vehicle within the configured engage limits.
Version 7.0, Revision A CFX-750 Display User Guide 221
To Next Page
Loading...
