13 Operations Map guidance and features
Record a FreeForm curve
1. Drive to the start point of the FreeForm curve.
2. To use:
ll
Manual recording, tap
l
Record with Coverage, tap either or
While the display is recording the current path, displays on the Guidance screen.
3. Drive the curve. To record straight sections, you can use the pause feature. See Guidance line /
pattern mapping, 203
4. To finish recording:
ll If Auto U-Turn Detection is on, perform a tight U-turn.
l
For Manual recording, tap .
l
If you are using Record with Coverage, tap or .
Note – If Auto U-Turn Detection option is off, you must manually stop recording at the end of
each pass and then start recording again at the beginning of the next pass.
Use the FreeForm pattern to define a straight AB line
1.
Tap and then drive to the end of the line.
2.
At the end of the line, tap .
Switch to another line
To switch from the current FreeForm guidance line to another, tap .
The first time you tap the button, guidance snaps to the next nearest curve. Continue tapping the
button to cycle through other guidance lines.
Note – To use this feature, the vehicle must be within 1.5 swath widths of a FreeForm curve.
Use FreeForm curves in spiral fields
If you are creating a spiral into the center of the field, drive the full circuit and then back onto the
start of the FreeForm curve. Continue to record your guidance path as you spiral toward the center
of the field.
210 CFX-750 Display User Guide Version 7.0, Revision A
To Next Page
Loading...