6 Field-IQ crop input control setup Field-IQ setup for implements
Setting Explanation
Implement Draft Distance that the implement drifts away from the center line of
the vehicle.
This setting is used to adjust the implement back on line if the
implement is physically drifting offline in the field.
This setting is similar to the Left/Right Offset.
Implement Mount Type The type of mount required:
ll
Hitched/3pt:Implement is mounted on a 3-point hitch,
meaning the implement rotates around the vehicle.
Note – When the vehicle makes a slight correction, you will
instantly see a change in the implement's location.
l
Drawbar:The implement is attached by a drawbar,
meaning the implement rotates around its ground contact
point.
Note – When the vehicle makes a correction, you may not
see a change in the implement until a certain distance has
been traveled
Implement switches
1. At the Implement Switches screen, tap Implement Lift Setup.
2. At the Implement Lift Setup screen, tap Implement Lift Enable.
3.
Tap Yes in the Implement Lift Enable screen and then tap .
122 CFX-750 Display User Guide Version 7.0, Revision A
To Next Page
Loading...
