13 Operations Map guidance and features
Internal pattern
The internal pattern is the pattern of the guidance lines inside the headland. An internal pattern can
be:
l Straight AB: Standard parallel swaths inside a headland
l A+: Parallel swaths at a pre-defined heading
Re-select the headland
When you use the headland pattern, you can see either the headland or the internal pattern.
To see the headland guidance again when you are driving the internal pattern, drive into the
headland before the first internal swath or after the final internal swath. The headland displays
automatically.
Map a headland
1. Drive to the start point of the headland.
2.
Tap to set the start point of the headland.
3.
Begin to drive the circuit of the headland.
Note – To ensure straight sides on the headland, you can use the pause feature. See
Guidance line / pattern mapping, 203.
4.
Tap to set the A point of your guidance line. If the internal pattern is an:
ll A+ line, the line is set.
l
An AB Line, continue to drive around the headland. When you reach the other end of the
internal guidance line, tap to set the B point.
When you define the internal pattern guidance line, the start-point circle displays around the
start point of the headland.
Note – If you return to the start of the headland before you define a guidance line, the
headland will not complete.
5.
Complete the headland.
Note – Define the master line for the internal pattern before you complete the headland.
To finish the headland, do either of these:
ll Drive around the rest of the headland until you return to the start-point circle. When you
drive into the start-point circle, the headland completes automatically.
208 CFX-750 Display User Guide Version 7.0, Revision A
To Next Page
Loading...
