Trimble CFX-750 - Implement Application Controller Setup

5 Implement application controller setup Implement application controller setup
Implement application controller setup
To setup an implement application controller (such as the Field-IQ crop input control system), you
start at the Implement screen.
To access the Implement screen:
1.
From the Guidance screen, tap .
2.
From the Settings screen, tap .
At the Implement screen are two options:
ll Advanced: Displays only after you have set up your controller using the Initial Setup
option
l Initial Setup: For initial setup of implement
3.
Tap Initial Setup. The Controller Type screen displays.
4.
Select the controller that you are using.
Note – To access all of the available Controller Type options (apart from None and Field-IQ)
you must have a VRA unlock code. To obtain a VRA unlock code, contact your Trimble reseller.
ll HARDI5500/6500 (see HARDI 5500 / 6500 controller setup, 94)
l Raven (see Raven controller setup, 97)
l Rawson (see Rawson controller setup, 99)
l Amazone (see Amazone controller setup, 102)
l LH5000 (see LH 5000 controller setup, 105)
l Vaderstad (see Vaderstad controller setup, 108)
l Bogballe (see Bogballe controller setup, 111)
Note – When you change the controller type, any open field will close.
92 CFX-750 Display User Guide Version 7.0, Revision A