Trimble CFX-750 - Frequency and baud rate

GNSS setup 10 GNSS setup
Setting Options
Internal Trimble Radio or
External Trimble Radio
If you tap one of the Trimble radio options for the
correction delivery method, you can also enter:
l
l Radio Network ID
l SecureRTK Keys
l SecureRTK Keys Status
l Use xFill™ (technology): tap Yes or No. If you tap
Yes, the xFill Lband Settings screen and RTK Base
Datumscreen display.
l xFill Lband Settings (tap the frequency and baud
rate)
l
RTK Base Datum: Select the datum that was used
when the RTK base station was surveyed. For more
information, contact your local reseller.
CAUTION – You must select the correct base datum for
your location.If you select an incorrect value, this will
result in an incorrect xFill operation.
Trimble VRS Modem or
CenterPoint RTX (std-cell)
If you select the Trimble VRS Modem or CenterPoint RTX
(std-cell) option for the correction delivery method, you
can also select your device (DCM-300 or Ag3000).
Any OmniSTAR® option or
CenterPoint RTX
If you select any OmniSTAR or CenterPoint RTX option
for the correction delivery method, also enter:
l
l Frequency and Baud Rate
l Threshold for Favor Accuracy
l FastRestart: On, Off
l RangePoint RTX: Satellite-based service available through a subscription
l Uncorrected: No GNSS corrections
l Ext. Corrections: tap when using corrections from an external correction source.
Frequency and baud rate
When receiving satellite signals, you must tap the frequency and baud rate based on your specific
region:
l Western North America (RTX WN): 1557.8615 MHz at 600 baud
l Central North America (RTX CN): 1557.8150 MHz at 2400 baud
l Eastern North America (RTX EN): 1557.8590 MHz at 600 baud
Version 7.0, Revision A CFX-750 Display User Guide 167