Trimble CFX-750 - Field-IQ Boom Height Control Setup

7 Boom Height Control setup Boom Height Control hardware installation
Boom Height Control hardware installation
For information on installing the Boom Height Control system on your equipment, refer to the
Boom Height Control Platform Installation Instructions. For the latest versions of these documents,
visit www.trimble.com/agriculture.
Field-IQ Boom Height Control setup
1.
At the Guidance screen, tap .
2.
At the Settings screen, tap .
3.
At the Implement screen tap Boom Height Control.
4.
At the Height Control screen, tap Height Control Setup Wizard.
5.
At the next screen, tap Enable and then tap .
6.
At the Welcome to Boom Height Control Setup screen, tap to start the Boom Height
Control Setup Wizard.
7.
At the Boom Control Option screen, select a control option and then tap .
Control Option Explanation
Monitor Only Auto-height control is not used. The SS100 sensors are used to
monitor the height above the crop or ground.
Left and Right Booms Auto-height control is used for the wings only.
Booms + Center Section Auto-height control is used for the wings and the center section.
8.
At the Hydraulic Valve Control Module screen, tap the serial number of the Hydraulic Valve
Control module and then tap .
9.
At the Height Sensor Setup screen, tap Number of Height Sensors.
Note – You must set up at least one sensor for each control zone to use the boom height
control system.
10.
At the Number of Height Sensors screen, choose the number of height sensors that are
attached to the boom and then tap .
11.
At the Height Sensor Setup screen, tap each of the sensor location buttons in sequence and
complete the settings. Then tap .
12.
Complete each sensor setting and then tap
142 CFX-750 Display User Guide Version 7.0, Revision A