WARNING – During the Deadzone calibration, the system moves the vehicle’s steering wheel. To avoid injury, be
prepared for sudden vehicle movement.
NH3, anhydrous ammonia
WARNING – Anhydrous valve and flow calibrations require the vehicle and implement to be moving and the
implement must be in the ground (the implement lift switch must be down). Take all necessary precautions to
ensure user safety. Failure to do so may result in serious injury or death.
WARNING – Anhydrous ammonia (NH3) can cause severe burning, blindness, or death. NH3 is an irritant and
corrosive to the skin, eyes, respiratory tract and mucous membranes, and is dangerous if not handled properly. It
may cause severe burns to the eyes, lungs, and skin. Skin, and respiratory-related diseases could be aggravated by
exposure. It is recommended that protective gloves, boots, slicker and/or pants and jacket, and chemical-splash
goggles that are impervious to anhydrous ammonia are worn at all times. See Safety Information, 17.
Cautions
Calibration
CAUTION – Failure to be in motion and in a straight path will cause performance problems after calibration.
Display
CAUTION – Do not use the Enable Advanced User Config feature unless you have the support of a Trimble
Reseller. Altering any of the settings for this feature may cause system failure.
CAUTION – Do not press on the screen with a sharp item, such as a pencil or screwdriver. You may damage the
surface of the screen.
EZ-Pilot system
CAUTION – Before you leave the vehicle, turn off the power to the display which will turn off the EZ-Pilot system
power.
CAUTION – If you use the vehicle on a public roadway, you must put the red EZ-Pilot system override switch in the
off position.
18 CFX-750 Display User Guide Version 7.0, Revision A
Safety Information
To Next Page
Loading...
Need help?
General
