7 Concurrent I/O (Input/Output)
7.4 Monitoring I/O from Smart Pendant Interface
7-9
HW1485509
HW1485509
Output signals can also be toggled from the Individual View. When
{Enable Toggle} checkbox is not checked, the output toggle switch is
disabled. When {Enable Toggle} checkbox is checked, the output toggle
switch is enabled for individual outputs. This is shown in fig. 7-5 “Toggle
Output from Individual View”.
Fig. 7-5: Toggle Output from Individual View
Go To an I/O Number
1. Press the text field to the right of {Go To:}.
– The keypad will appear.
2. Enter the I/O number and press {Enter}.
– The view will go to the I/O number and highlight it.
I/O Settings
To access I/O Settings, press the {SETTINGS} on the top of the panel.
This will bring up the panel shown in fig. 7-6 “I/O Display Settings”.
This panel has two sections: Display Settings (1) and Types to Display (2).
In the {Display Settings}, the view can be switched between the Group
View and Individual View that are mentioned in the previous sections.
In the {Types to Display}, the I/O display can be filtered based on how the
I/O are configured on the YRC Controller. For example, if all checkboxes
were cleared except the “Terminal Block”, then only the I/Os associated
with the standard Terminal Blocks would be displayed
(i.e. 1-24 for YRC1000 and 1-8 for YRC1000micro).
To Next Page
Loading...
