Copying and renaming points
ADM003GVAE1005 145
• Enter the Destination Points. The user can also use asterisks. These points
will be renamed according to the defined Source points
• Click Copy (or Rename, if renaming). A message is displayed warning the
user that any Graphics or Reports that reference the point(s) that are about
to be renamed may now be invalid
• If the point(s) are renamed successfully the Database Copy/Rename Status
dialog box will indicate a status of OK, otherwise it will indicate the reason
why the rename failed. When renaming multiple points the Database Copy/
Rename Status dialog box will indicate which points were successfully
renamed and which failed
• Click OK. Changes or new points appear in database
Point Copy /Rename dialog box
SOURCE POINTS These fields define the FuelsManager database point to
be used as the source for the copy / rename action.
Wildcard characters allow the user to copy an entire
database level at once.
DESTINATION
POINTS
These fields define the FuelsManager database point to
be created by the copy / rename action. Wildcard
characters allow the user to copy an entire database level
at once.
COPY
DESCRIPTION
Copy the description of the source point to the destination
point.
COPY ALARMS Copy the alarms associated with the source point to the
destination point.
COPY TANK STRAP
TABLE
Copy the tank strapping table of the source point to the
destination point.
COPY PRODUCT Copy the product assigned to the source point to the
destination point.
To Next Page
Loading...