FuelsManager Defense
2 Administrator Manual
Before You Begin
This section describes how to install FuelsManager. This chapter also provides an
overview of how a system could be networked.
In most cases, FuelsManager is installed and pre-configured on the computers
before they arrive on site. Further information on how to use the Operate user
interface to interact with the facility during run-time is provided in the user manual.
When and if other database components need to be edited or changed, refer to
Databases Chapter in this manual.
Note! If FuelsManager has not
been configured, the Administrator
should perform the all the
procedures in this chapter.
Once FuelsManager has been installed, the user should then refer to the Setting
System Parameters chapter which addresses the configuration procedures to
provide complete functionality of this software.
Before you begin installation make sure:
• The computer meets the minimum requirements listed in the Hardware
Requirements section
• The installation is to a Windows NTFS file system. If one does not exist, you
must create and format an NTFS partition. See Windows documentation for
further information
• You log into Windows 2000/XP as Administrator to install FuelsManager. The
system administrator has complete authority for installing FuelsManager,
setting up Windows users, and defining FuelsManager users
• You close all other applications before installing
What’s in the Box
The items delivered as part of this installation include:
• Install CD-ROM
• Hardware Key
• Keyboard Template
• Mouse Pad
To Next Page
Loading...