FuelsManager Defense
244 Administrator Manual
ArchiveManager
The ArchiveManager database is analyzed to calculate leak rates. It is necessary
to configure ArchiveManager to write all required data to the archive database:
• ArchiveManager needs to be configured to include the following additional
tank point variables:
In addition, the following ArchiveManager Configuration changes must be made:
• The precision of the Tank Level should be increased to allow Leak Detection
to calculate small volume changes
• ArchiveManager’s sample Interval should be set to 5 minutes
• ArchiveManager’s Historical Period should be set to 60 or 90 days
For details on how to add the necessary additional tank point variables, and
configure the precision and historical period, see the Archiving information section
of this manual.
The following section details how to override the ArchiveManager minimum
sample interval of 10 minutes and set the sample interval to 5 minutes.
Cathodic Protection Standard Density
Date Installed Tank Gauge Type
Density Tank Height
Hydro Pressure Units Tank Level
Hydro Pressure Volume Tank Material
Bottom Pressure P1 Tank Radius
Leak Rate Tank Volume
Leak Rate Units Temperature
Lining Material Unrounded Volume Net
Overfill Protection Water Level
Spill Protection
To Next Page
Loading...